共面波导效应对射频电路板的影响及其应用

文章简要介绍了共面波导的定义及特点,详细分析了在射频PCB设计中的共面波导效应及其对微带传输线的影响,同时分析介绍了利用共面波导效应画传输线的方法。     

氩工质连续激光加热推力器的数值仿真

对氩气工质的连续激光推力器内加热与流动过程进行数值模拟,建立了包含激光吸收、化学反应、高温效应、黏性、扩散、热传导以及辐射效应等物理机制的模型.推力室内二维轴对称流场采用可压缩Navier-Stokes方程描述,用SIMPLEC(semi-implicit method for pressure-linked equa...     

Application of small-size antennas for estimation of angles of arrival of HF signals scattered by ionospheric irregularities

A modification of the Doppler Interferometry Technique is suggested to enable estimating angles of arrival of comparatively broadband HF signals scattered by random irregularities of the ionospheric plasma with the use of small-size weakly directional antennas. The technique is based on the measurements of cross-spectra phases of the probe radiation recorded at least in three spatially separated points. The developed algorithm has been used to investigate the angular and frequency-time characteristics of HF signals propagating at frequencies above the maximum usable one (MUF) for the direct radio path Moscow-Kharkiv. The received signal spectra show presence of three families of spatial components attributed, respectively, to scattering by plasma irregularities near the middle point of the radio path, ground backscatter signals and scattering of the sounding signals by the intense plasma turbulence associated with auroral activations. It has been shown that the regions responsible for the formation of the third family components are located well inside the auroral oval. The drift velocity and direction of the auroral ionosphere plasma have been determined. The obtained estimates are consistent with the classical conception of the ionospheric plasma convection at high latitudes and do not contradict the results of investigations of the auroral ionosphere dynamics using the SuperDARN network.     

不同温度下TC21钛合金等离子表面渗Cr层的摩擦磨损性能

为提高TC21合金的摩擦磨损性能，采用双辉等离子冶金技术在TC21合金表面制备渗Cr改性层，利用扫描电镜(Scanning electron microscope,SEM),能谱仪(Energy dispersive spectromenter,EDS),显微硬度仪和划痕仪等研究了渗Cr层的组织形貌特征、硬度及结合强度，并 在20,300,500 ℃条件下使用摩擦磨损试验机对基体及渗Cr层的摩擦磨损性能进行对比、探究，并分析磨损机理。结果表明：渗Cr层厚度为30μm，均匀致密，与基体结合力至少能承受64 N的垂直载荷；改性层表面硬度超过1 000 HV0.1，约为基体的3倍；TC21合金渗Cr后，不同温度下的减摩性能和耐磨性能均得到提高。在室温下TC21基体磨损机理主要是磨粒磨损、粘着磨损和氧化磨损，而渗Cr层的磨损机理主要是磨粒磨损；500 ℃时基体粘着磨损和氧化磨损程度变得更加严重，渗Cr层磨损机理是剥层磨损和氧化磨损。      

自制等离子喷枪冷却系统的设计及测试

等离子喷枪是制备热障涂层中的研究重点。目前关于等离子喷枪的研究多集中于喷嘴(阳极)、阴极,鲜有关于喷枪冷却系统方面的研究;喷枪冷却系统的优劣直接影响喷枪的工作寿命和喷涂过程的稳定性,同时制备热障涂层的质量也与冷却效果紧密相关。本文利用三维模型,详细阐述了自制的喷枪冷却系统通道及工作原理,并对设计进行了理论计算,对自制的喷枪进行点火试验和喷涂测试,结果显示自制的喷枪冷却系统功能良好,喷枪工作稳定,涂层质量较好。     

基于新型丝状电极等离子体激励器的前体涡控制

本文首次将新型丝状暴露电极DBD等离子激励器应用于大迎角下细长体非对称涡控制。丝状暴露电极的材料的选择对DBD推力以及推力效率至关重要,通过地面精细推力测量对丝状暴露电极等离子体激励器进行了优化,结果表明,本文研究材料中采用钨丝作为暴露电极,其推力效率最优;且随着电极直径从d=0.3 mm减小到d=0.08 mm,DBD推力效率显著提升。基于优化后的DBD激励器,将其应用于前体非对称涡控制:未施加等离子体控制时,压力测量以及PIV结果均表明细长体背风区流场为明显的非对称涡结构;在等离子体激励下,该非对称涡结构可变为对称甚至反向非对称,且非稳态激励控制能力明显优于稳态激励。研究发现,大迎角下细长体非对称涡控制与背风区原始涡系结构有关,其中包含对称涡系和非对称涡系。本文研究为大迎角下细长体非对称涡控制提供了一种新思路,同时也为丝状暴露电极DBD等离子体激励器的应用提供参考。     

三角翼DBD等离子体流动控制研究进展

现代战机采用较多的三角翼，在大迎角绕流时存在前缘涡破裂等气动问题。作为新型主动流动控制技术，等离子体激励频带宽、响应快、结构简单、便于闭环控制，在解决三角翼气动问题上具有潜力。回顾了介质阻挡放电（DBD）等离子体气动激励的基本原理，及其用于三角翼前缘涡控制的研究进展。从来流条件、几何构型、激励参数等方面分析了DBD等离子体激励对流动控制效果的影响规律；结合不同激励频率下流场演化特性，分析了流动控制机理。最后，从理论研究和工程应用的角度，对三角翼前缘涡控制的发展进行总结展望。     

Study of GNSS-measured ionospheric total electron content variations generated by powerful HF-heating

The purpose of this work is to report the experimental evidences for the influence of perturbations in the electron density in the dayside mid-latitude ionosphere, that are caused by high-frequency heating of the F2 layer, on the GNSS signals. The experiments were carried out at the Sura heater (Radio Physical Research Institute, N. Novgorod). During the sessions of ionospheric heating with different time modulations of the radiated power the rays linking the navigational satellites with the ground receiver intersected the heated region. Variations in the total electron content (TEC) were studied; these variations are proportional to the reduced phases of navigational signals. It is shown that with the square-wave modulation of the radiated power (with periods of 1, 6, 10 and 15 min), perturbations with periods of the main modulation of heating and its harmonics appear in the spectrum of TEC variations. Examples are presented of identification of the heating-induced variations in TEC, including determination of the amplitudes and time characteristics of these variations.     

一种射频仿真时统子系统的技术设计

针对射频仿真系统中的时间同步问题,设计基于FPGA、DSP和GPS的时间统一系统。从工程实施的角度出发,详细阐述时统的硬件设计,介绍IRIG-B码的解码原理和各采样频率信号输出的过程。试验证明：该时统克服了常规时统设备的不足,性能更稳定,可靠性更高,更易于调试。     

Mathematical modeling of plasma drifts over equatorial low latitude regions

This paper presents a mathematical model to simulate ionospheric plasma drifts at equatorial low latitude regions by coupling of E- and F-regions. The governing non-linear differential equations (of elliptic and parabolic nature) are solved numerically through finite-difference schemes and obtained neutral winds and electric fields. The temperature and electron density profiles are generated utilizing MSIS-86 atmospheric model. The continuity equation is employed to obtain night-time E-region density profile using measured ionograms at Trivandrum (India). The computed vertical and zonal plasma drifts are comparable with measured Jacamarca plasma drifts with little variations during noon and evening times. The plasma drifts at Trivandrum (8.5° N, 76.5° E, dip 0.5° N) are compared with those of Jicamarca (12° S, 76.9° W, dip 2° N). Neutral wind simulations of present model agree well with those of horizontal wind model (HWM-93). The post-sunset enhancement and its reversal are also discussed.